AcuRite 00278A2 Manuel d'instructions télécharger pdf (Page 9)

Check Probe

“CHECK PROBE” indicates a probe error and is shown with a diagnostic code:

Diagnostic

Code

Problem Solution

Probe cord is not connected

to the thermometer.

Verify cord connection is

secure or reconnect cord.

Probe cord is not functioning

properly. Cord may have

been damaged or exposed

to extreme heat.

Check the wire and connection

for damage or excessive heat.

Replace cord.

Remote Pager

Lights Solution

Red & Green Blinking No wireless connection. See Troubleshooting tips.

Red Solid Replace the batteries.

Troubleshooting

Problem Possible Solution

Inaccurate

temperature

• Use standard alkaline batteries. Do not use

heavy duty or rechargeable batteries.

Check Probe

• Review Probe Messages (above)

Display screen

not working

• Verify batteries are installed correctly. Batteries

may need to be replaced.

Pager lights are blinking

• Relocate the thermometer and pager.

The units must be within 200 ft (60 m) of each

other.

• Make sure both units are placed at least 3 feet

(.9 m) away from electronics that may interfere

with the wireless communication (such as TVs,

microwaves, computers, etc).

If your AcuRite product does not operate properly after trying

the troubleshooting steps, visit www.AcuRite.com or call

(877) 221-1252 for assistance.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

AcuRite 00278A2 Manuel d'instructions Page 9